Think how versatile this could be — just swap the mason jars for another style of glass shade!
Here’s LZ with the tutorial:
How to Upcycle a Vanity Light Strip into a Pendant Light or Chandelier
by LZ from The Summery Umbrella
Hello Remodelaholics! I’m LZ Cathcart and I’m the creative mind behind The Summery Umbrella. I enjoy sharing my adventures in DIY projects with my super talented husband, as well as my love for creating wall décor from reclaimed wood in my shop. You’ll find that I primarily focus my attention on what I call the 3 R’s. Rustic, Repurpose and Repaint. I like to keep it simple, but pretty and unique at the same time! To illustrate my design style and also some of my all-time favorite DIY projects check out these beauties: Upcycled Lamp Shade Pendant Light, Rustic & Industrial Bucket Light, and Reclaimed Wood Pumpkins.
- 40” L x 8.5” W x 1” thick piece of reclaimed barn wood
- Repurposed Bathroom Light Vanity Strip
- Spray Paint
- 6 Mason Jars
- 6 Edison Light Bulbs
- Drill and Bits
- Screws
- Rope
2.) Next, drill a hole into the barn wood with a 2 1/8 inch drill bit for the electrical wires.
3.) Pull apart the light fixture so it can be attached to the barn wood. Drill four holes; one on each end and two in the middle to secure just the inside piece of your light strip to the piece of barn wood.
4.) Attach the exterior part of your light fixture (this particular one just clipped back into place).
5.) Drill holes into the Mason jar lids using 1 3/8 inch drill bit for the light socket opening. Use a 1/8 inch drill bit to pre-drill two holes into each lid so they
also can be securely fastened to the fixture.
6.) Place the Mason jar bands on first, then the lids and finally screw them in. You can also screw in the light bulbs and Mason jars at this point if you want to get a preview of
your new light.
9.) Measure from the ceiling down to approximately how high above your table you would like your light fixture to hang. The length of the rope and height of the light fixture will depend on where you are hanging it and the height of your ceiling.
We absolutely LOVE how our Mason jar pendant light turned out, and it is definitely at the top of our list of favorite DIY projects in our new home. The cost of this project will ultimately depend on the materials you already have on hand.
The wood piece we used is from an old barn that my husband tore down, and it is made of Hemlock Pine.
Since we repurposed our former bathroom vanity light there was no cost here either, but you can find one similar to this on Amazon for $28.
We already had Mason jars, but you can find them for around $10 for six, and this particular spray paint is typically $6 a can.
The cost of rope varies depending on the material used, diameter, and length; prices range from $10-$40.
As for the light bulbs, this is where we spent most of our money. You can choose whatever lights you prefer, but we bought a 6 pk of Nostalgic Edison Squirrel Cage style bulbs on Amazon for $32.
———————————-
Be sure to pay LZ a visit over at The Summery Umbrella to check out more, like easy wire mesh baskets and reclaimed barnwood kitchen countertops.
And be sure to subscribe to follow us by RSS or email so you don’t miss a single one of our amazing holiday guests!
You can also follow along on social media: Facebook | Instagram | Google+ | Twitter | Pinterest
Want to be featured here on Remodelaholic? Submit your best project here.
More DIY chandeliers:
Knockoff Crystal Orb Chandelier 
Thank you so much again for the feature. You guys rock! If anyone has any questions just let me know! Thanks again 🙂
Thanks, LZ!!
Did you use quart or pint size mason jars?
What size mason jars did you use?
I would like to learn more DYI, something to do when I retire and to replace or refurbish items. Always looking for simple expensive ideas to fix up my home. Like the Manson jar lights would look great over my counter/bar.
Thanks, Patricia!
Do the mason jars get hot when the light is on? That would be my one worry that the jars would get too hot from the light bulbs.
Hi Rose, and great question! I’ve had this particular light up for about four months now, and haven’t had any issues with overheating. My daughter loves to turn this light on all the time so as of right now…. no problems here 🙂
If you think about it, mason jars are used for canning and most items need to boiling hot when they are put in the mason jar and then the seal & lid are put on and then the full mason jar must be put into a boiling pot again to sterilize & seal the jar.
Light bulbs won’t put off that much heat! I hope your enjoying your new lights!
I don’t worry so much about the jars getting hot, as I would the wood they are attached to…does the heat transfer from the lids to the wood?
Just curious..before you screwed in the jars, did you have to drill any holes into the jars for ventilation? I would think the jars would get too hot from the light bulb. Thanks!
Hi Beverly! We did not drill any holes for ventilation, and as of right now overheating has not been an issue. Thanks for the question.
Did you have to buy a wire kit to connect the hard wires from the back of the light to the black cord?
Hi Jennifer! We did not. We were very fortunate, and were able to use the existing wiring in the vanity light as well as the electrical outlet in the ceiling. However, if you’re not familiar with electrical wiring please consult a licensed electrician. Great question! 🙂
LOVE, LOVE, LOVE THIS! Featured on Ana-White.com today! Thanks for sharing this amazing tutorial!
Thanks for the feature!
Thank you so much! 🙂
I think I have 1 of those fixtures with 3 lights. Could I wire that to a lamp type cord and plug in, rather than hard wire in ceiling??
I believe it could, but it all depends on the wattage and wattage ratings of your fixture and cord. If you are not familiar with electricity it wouldn’t hurt to consult a qualified electrician. Safety first! 🙂
What size mason jars did you use here, quart? Wide mouth quart? And what rope did you use? thanks!! I’m going to attempt this with 2, 5 light fixtures we’re taking out of our master and use over our large dining tabl . Very excited!
Hi Molly! That’s awesome, and how exciting! I used wide mouth, quart size mason jars (I believe Walmart has the best price for buying in bulk), and then the rope is Blue Hawk Twisted Sisal Rope that is the 48 lb and 100 ft version (I believe I purchased it from Lowe’s). Just let me know if you have any other questions!
Ok I’m stuck on step 10 and can’t seem to figure out from the intructions how you secured the ropes. I understood that one rope is long enough to go up to make the loop and then wind around for the “noose” look but did you tie off the others somewhere? Thanks for your help.
Hi Molly! The ropes are secured by the knots underneath the board. For instance, one strand is for the left side (the length) and after you knot each corner you’ll be left with a “handle” for that side. You’ll repeat this step on the right side. With these two “handles” you’ll take your third strand, and then loop the two strands together. Last, tie a knot at the top on your third strand. The fourth strand is just for decoration to make everything look pretty. Hopefully this helps, but if not, just let me know 🙂
Yes!! Makes perfect sense now thank you!!
How did you drill the hole in the lid? Like, how did you keep the lid steady while drilling? A clamp or did you hold the bottle with the lid on?
Hi Karissa! If you have trouble holding the lid while you are drilling in your holes I highly recommend using a clamp. This is definitely my favorite method!
Had a question I ordered some vintage bulbs online from Amazon but mine are too big and the ones you tagged seem to be the same size. Mine were 6.5″ long and about 2.5″ wide. The widest Mason jars I’ve found have been 2.25″ inches and only 6″ or so deep. Any suggestions?
Hi George! I used wide mouth, quart size mason jars (I believe Walmart has the best price for buying in bulk). Thanks for stopping by, and best of luck!
Hi I am wondering how you wired the fixture. My bathroom light only has a short wire. How did you get such a long wire on yours?
Do you have a problem with the chandelier spinning off center. It would drive me crazy if it didn’t stay parallel to the table.
I love this idea. Our local Habitat Restore had several of these vanity lights. So, I’ve decided to do this,this weekend .
Send us pictures when you’re done! 🙂 https://www.remodelaholic.com/share-brag-post/
Hi. I love this. I have all my items to make!! Just wondering. Did you do anything to let the heat from bulbs able to come out?
Thank you
Do you think this light fixture would be safe to put above a tub?
You’d have to check your local building code to be sure — the code varies by state, I believe.
I LOVE, LOVE, LOVE this project!! You did a fabulous job and it shows!! Thank you for all the instructions too!! ❣️❣️❣️
Did your old light fixture have a super long wire? Mine has a hot, cold, and ground, (black, white, & green) and they’re only about 10″ long. I’m guessing because it was mounted against the wall, they didn’t need the length?
I don’t understand how you got the single cord to go all the way up the rope and connect to the recepticle. Maybe I missed something? Thanks for any advice!